Figure: 30 TAC §113.2074(a)

Table 3. Initial and Annual Inspection Requirements.

Items to be Inspected	Requirements
Burners, pilot assemblies, and pilot sensing devices	Inspect for proper operation; clean pilot flame sensor, as necessary.
Combustion air	Ensure proper adjustment of primary and secondary chamber combustion air, and adjust as necessary.
Hinges and door latches	Inspect and lubricate as necessary.
Dampers, fans, and blowers	Inspect for proper operation.
Incinerator door and door gaskets	Inspect for proper sealing.
Motors	Inspect for proper operation.
Primary chamber refractory lining	Inspect lining; clean and repair/replace as necessary.
Incinerator shell	Inspect for corrosion and/or hot spots.
Secondary/tertiary chamber and stack	Inspect and clean as necessary.
Mechanical loader, including limit switches	Inspect for proper operation, if applicable.
Waste bed (grates)	visually inspect and repair/seal, as appropriate.
Air pollution control device(s)	Inspect device(s) for proper operation, if applicable.
Waste heat boiler systems	Inspect to ensure proper operation, if applicable.
Bypass stack components	Inspect components.
Thermocouples, sorbent feed systems, and any other monitoring equipment	Ensure proper calibration of equipment.
General equipment	Generally observe that the equipment is maintained in good operating condition.
Incinerator operation	For the burn cycle that follows the inspection, document that the incinerator is operating properly and make any necessary adjustments.