(a) Standards--Federal Motor Vehicle Safety Standard
(FMVSS). The standard for vehicle equipment established by the Texas
Department of Public Safety is identical to the applicable federal
standard.
(1) Lamps, Reflective Devices, and Associated Equipment--FMVSS
108. The standard detailed in this paragraph applies to lamps, reflective
devices, and associated equipment installed on a vehicle as original,
replacement, or aftermarket equipment. No additional lamp, reflective
device, equipment, or other material is permitted to be installed
on a vehicle that impairs the effectiveness of, or interferes with,
lighting or reflective devices required by this standard. A lamp or
reflective device installed in a location and manner described by
FMVSS 108 must meet the prescribed color requirements regardless of
whether or not the lamp or device is required equipment. The standards
for the lamps, reflective devices, and associated equipment in subparagraphs
(A) - (R) of this paragraph are described in FMVSS 108:
(A) backup lamp;
(B) clearance lamp;
(C) hazard warning lamp, signal, flashers, and switches;
(D) headlamp--sealed and nonsealed beam and housing;
(E) identification lamp;
(F) license plate lamp;
(G) parking lamp (front position lamps);
(H) reflex reflector;
(I) intermediate side reflex reflectors;
(J) replacement lenses;
(K) school bus alternating warning lamp, signal, flashers,
and switches;
(L) side marker lamp;
(M) intermediate side marker lamps;
(N) stop signal lamp;
(O) high-mounted stop lamp;
(P) tail lamp (rear position lamps);
(Q) turn signal lamp, signal, flashers, and switches;
and
(R) conspicuity systems (retroreflective and reflex
reflectors for truck tractors, and trailers over 80 inches wide and
with gross vehicle weights over 10,000 pounds).
(2) Warning Devices--FMVSS 125. This standard applies
to devices, without self-contained energy sources, designed to be
carried in motor vehicles and used to warn approaching traffic of
the presence of a stopped vehicle, except for devices designed to
be permanently affixed to the vehicle.
(3) Safety glass and glazing--FMVSS 205.
(4) Seat belts--FMVSS 209.
(b) Standards--Society of Automotive Engineers (SAE).
The standard for vehicle equipment established by the Texas Department
of Public Safety in which no federal standard is in effect is identical
to the applicable standard adopted by the Society of Automotive Engineers.
(1) Lighting devices (auxiliary)--SAE:
(A) auxiliary low beam (passing lamp)--J582;
(B) driving lamp--J581;
(C) fog lamp--J583;
(D) spot lamp--J591;
(E) high mounted stop and turn signal lamp--J186;
(F) cornering lamp--J852;
(G) side turn signal lamp--J914;
(H) flashing warning lamp for emergency vehicle--J595;
and
(I) 360-degree emergency warning lamp--J845.
(2) Special vehicle equipment--SAE:
(A) warning lamp alternating flashers--J1054; and
(B) motorcycle auxiliary front lamps--J1306.
|
Source Note: The provisions of this §21.2 adopted to be effective April 12, 2012, 37 TexReg 2430; amended to be effective January 12, 2015, 40 TexReg 256; amended to be effective November 17, 2022, 47 TexReg 7561 |