| (a) The provisions of this subchapter implement Federal Clean Air Act (FCAA), §112(g), Modifications, and 40 Code of Federal Regulations (CFR) Part 63, Hazardous Air Pollutants: Regulations Governing Constructed or Reconstructed Major Sources, Subpart B, Requirements for Control Technology, as amended December 27, 1996. Affected sources (as defined in §116.15(1) of this title (relating to Section 112(g) Definitions)) subject to this subchapter are those sources for which the United States Environmental Protection Agency has not promulgated a maximum available control technology (MACT) standard under 40 CFR Part 63. For purposes of this subchapter, the following terms apply. (1) Construct a major source--As follows. (A) To fabricate, erect, or install at any green field site a stationary source or group of stationary sources that are located within a contiguous area and under common control and that emit or have the potential to emit ten tons per year of any hazardous air pollutant (HAP) or 25 tons per year of any combination of HAPs; (B) to fabricate, erect, or install at any developed site a new process or production unit that in and of itself emits or has the potential to emit ten tons per year of any HAP or 25 tons per year of any combination of HAPs, unless the process or production unit satisfies clauses (i) - (vi) of this subparagraph: (i) all HAPs emitted by the process or production unit that would otherwise be controlled under the requirements of this subchapter will be controlled by emission control equipment that was previously installed at the same site as the process or production unit; (ii) either of the following regarding control of HAP emissions: (I) the executive director has determined within a period of five years prior to the fabrication, erection, or installation of the process or production unit that the existing emission control equipment represented best available control technology (BACT), lowest achievable emission rate (LAER) under 40 CFR Part 51 or Part 52, toxics-best available control technology (T-BACT), or MACT based on state air toxic rules for the category of pollutants that includes those HAPs to be emitted by the process or production unit; or (II) the executive director determines that the control of HAP emissions provided by the existing equipment will be equivalent to that level of control currently achieved by other similar sources using a level of control equivalent to current BACT, LAER, T-BACT, or state air toxic rule MACT determination; (iii) the executive director determines that the percent control efficiency for emissions of HAP from all sources to be controlled by the existing control equipment will be equivalent to the percent control efficiency provided by the control equipment prior to the inclusion of the new process or production unit; (iv) the executive director has provided notice and an opportunity for public comment concerning the determination that criteria in clauses (i) - (iii) of this subparagraph apply and concerning the continued adequacy of any prior LAER, BACT, T-BACT, or state air toxic rule MACT determination; (v) if any commenter has asserted that a prior LAER, BACT, T-BACT, or state air toxic rule MACT determination is no longer adequate, the executive director has determined that the level of control required by that prior determination remains adequate; and (vi) any emission limitations, work practice requirements, or other terms and conditions upon which the determinations in clauses (i) - (v) of this subparagraph are predicated will be construed by the executive director as applicable requirements under FCAA, §504(a), and either have been incorporated into any existing permit issued under Chapter 122 of this title (relating to Federal Operating Permits) for the affected source (as defined in §116.15(1) of this title) or will be incorporated into such permit upon issuance. (2) Reconstruct a major source--The replacement of components at an existing process or production unit that in and of itself emits or has the potential to emit ten tons per year of any HAP or 25 tons per year of any combination of HAP, whenever: (A) the fixed capital cost of the new components exceeds 50% of the fixed capital cost that would be required to construct a comparable process or production unit; and (B) it is technically and economically feasible for the reconstructed major source to meet the applicable MACT emission limitation for new sources established under this subchapter. (b) The requirements of this subchapter apply to an owner or operator of an affected source (as defined in §116.15(1) of this title) that constructs or reconstructs, unless the affected source in question has been specifically regulated or exempted from regulation under a standard issued under FCAA, §112(d), (h), or (j) and incorporated in another subpart of 40 CFR Part 63, or the owner or operator of such affected source has received all necessary air quality permits for such construction or reconstruction project. (c) Affected sources (as defined in §116.15(1) of this title) subject to the requirements of this subchapter are not eligible to use a standard permit under Subchapter F of this chapter (relating to Standard Permits) unless the terms and conditions of the specific standard permit meet the requirements of this subchapter. |
