Unless specifically defined in the Texas Clean Air Act or Chapter
101 of this title (relating to General Air Quality Rules), the terms
in this chapter have the meanings commonly used in the field of air
pollution control. Additionally, the following meanings apply, unless
the context clearly indicates otherwise. Additional definitions for
terms used in this chapter are found in §3.2 and §101.1
of this title (relating to Definitions).
(1) Annual capacity factor--The total annual fuel consumed
by a unit divided by the fuel that could be consumed by the unit if
operated at its maximum rated capacity for 8,760 hours per year.
(2) Applicable ozone nonattainment area-The following
areas, as designated under the 1990 Federal Clean Air Act Amendments.
(A) Beaumont-Port Arthur ozone nonattainment area--An
area consisting of Hardin, Jefferson, and Orange Counties.
(B) Bexar County ozone nonattainment area-An area consisting
of Bexar County.
(C) Dallas-Fort Worth eight-hour ozone nonattainment
area--An area consisting of:
(i) for the purposes of Subchapter D of this chapter
(relating to Combustion Control at Minor Sources in Ozone Nonattainment
Areas), Collin, Dallas, Denton, Ellis, Johnson, Kaufman, Parker, Rockwall,
and Tarrant Counties; or
(ii) for all other divisions of this chapter, Collin,
Dallas, Denton, Ellis, Johnson, Kaufman, Parker, Rockwall, Tarrant,
and Wise Counties.
(D) Houston-Galveston-Brazoria ozone nonattainment
area--An area consisting of Brazoria, Chambers, Fort Bend, Galveston,
Harris, Liberty, Montgomery, and Waller Counties.
(3) Auxiliary steam boiler--Any combustion equipment
within an electric power generating system, as defined in this section,
that is used to produce steam for purposes other than generating electricity.
An auxiliary steam boiler produces steam as a replacement for steam
produced by another piece of equipment that is not operating due to
planned or unplanned maintenance.
(4) Average activity level for fuel oil firing--The
product of an electric utility unit's maximum rated capacity for fuel
oil firing and the average annual capacity factor for fuel oil firing
for the period from January 1, 1990, to December 31, 1993.
(5) Block one-hour average--An hourly average of data,
collected starting at the beginning of each clock hour of the day
and continuing until the start of the next clock hour.
(6) Boiler--Any combustion equipment fired with solid,
liquid, and/or gaseous fuel used to produce steam or to heat water.
(7) Btu--British thermal unit.
(8) Chemical processing gas turbine-A gas turbine that
vents its exhaust gases into the operating stream of a chemical process.
(9) Continuous emissions monitoring system (CEMS)--The
total equipment necessary for the continuous determination and recordkeeping
of process gas concentrations and emission rates in units of the applicable
emission limitation.
(10) Daily--A calendar day starting at midnight and
continuing until midnight the following day.
(11) Diesel engine--A compression-ignited two- or four-stroke
engine that liquid fuel injected into the combustion chamber ignites
when the air charge has been compressed to a temperature sufficiently
high for auto-ignition.
(12) Duct burner--A unit that combusts fuel and that
is placed in the exhaust duct from another unit (such as a stationary
gas turbine, stationary internal combustion engine, kiln, etc.) to
allow the firing of additional fuel to heat the exhaust gases.
(13) Electric generating facility (EGF)--A unit that
generates electric energy for compensation and is owned or operated
by a person doing business in this state, including a municipal corporation,
electric cooperative, or river authority.
(14) Electric power generating system--One electric
power generating system consists of either:
(A) for the purposes of Subchapter C, Divisions 1,
2, and 4 of this chapter (relating to Beaumont-Port Arthur Ozone Nonattainment
Area Utility Electric Generation Sources; Bexar County Ozone Nonattainment
Area Utility Electric Generation Sources; and Dallas-Fort Worth Eight-Hour
Ozone Nonattainment Area Utility Electric Generation Sources), all
boilers, auxiliary steam boilers, and stationary gas turbines (including
duct burners used in turbine exhaust ducts) at electric generating
facility (EGF) accounts that generate electric energy for compensation;
are owned or operated by an electric cooperative, municipality, river
authority, public utility, independent power producer, or a Public
Utility Commission of Texas regulated utility, or any of its successors;
and are entirely located in one of the following ozone nonattainment
areas:
(i) Beaumont-Port Arthur;
(ii) Bexar County; or
(iii) Dallas-Fort Worth eight-hour;
(B) for the purposes of Subchapter C, Division 3 of
this chapter (relating to Houston-Galveston-Brazoria Ozone Nonattainment
Area Utility Electric Generation Sources), all boilers, auxiliary
steam boilers, and stationary gas turbines (including duct burners
used in turbine exhaust ducts) at EGF accounts that generate electric
energy for compensation; are owned or operated by an electric cooperative,
municipality, river authority, public utility, or a Public Utility
Commission of Texas regulated utility, or any of its successors; and
are entirely located in the Houston-Galveston-Brazoria ozone nonattainment
area;
(C) for the purposes of Subchapter B, Division 3 of
this chapter (relating to Houston-Galveston-Brazoria Ozone Nonattainment
Area Major Sources), all units in the Houston-Galveston-Brazoria ozone
nonattainment area that generate electricity but do not meet the conditions
specified in subparagraph (B) of this paragraph, including, but not
limited to, cogeneration units and units owned by independent power
producers; or
(D) for the purposes of Subchapter E, Division 1 of
this chapter (relating to Utility Electric Generation in East and
Central Texas), all boilers, auxiliary steam boilers, and stationary
gas turbines at EGF accounts that generate electric energy for compensation;
are owned or operated by an electric cooperative, independent power
producer, municipality, river authority, or public utility, or any
of its successors; and are located in Atascosa, Bastrop, Brazos, Calhoun,
Cherokee, Fannin, Fayette, Freestone, Goliad, Gregg, Grimes, Harrison,
Henderson, Hood, Hunt, Lamar, Limestone, Marion, McLennan, Milam,
Morris, Nueces, Parker, Red River, Robertson, Rusk, Titus, Travis,
Victoria, or Wharton County, or in Bexar County until December 31,
2024.
(15) Emergency situation--As follows.
(A) An emergency situation is any of the following:
(i) an unforeseen electrical power failure from the
serving electric power generating system;
(ii) the period of time that an Electric Reliability
Council of Texas, Inc. (ERCOT)-issued emergency notice or energy emergency
alert (EEA) (as defined in ERCOT Nodal Protocols,
Section 2: Definitions and Acronyms (August 13, 2014) and issued
as specified in ERCOT Nodal Protocols, Section
6: Adjustment Period and Real-Time Operations (August 13, 2014))
is applicable to the serving electric power generating system. The
emergency situation is considered to end upon expiration of the emergency
notice or EEA issued by ERCOT;
(iii) an unforeseen failure of on-site electrical transmission
equipment (e.g., a transformer);
(iv) an unforeseen failure of natural gas service;
(v) an unforeseen flood or fire, or a life-threatening
situation;
(vi) operation of emergency generators for Federal
Aviation Administration licensed airports, military airports, or manned
space flight control centers for the purposes of providing power in
anticipation of a power failure due to severe storm activity; or
(vii) operation of an emergency generator as part of
ERCOT's emergency response service (as defined in ERCOT Nodal Protocols, Section 2: Definitions and
Acronyms (August 13, 2014)) if the operation is in direct response
to an instruction by ERCOT during the period of an ERCOT EEA as specified
in clause (ii) of this subparagraph.
(B) An emergency situation does not include:
(i) operation for training purposes or other foreseeable
events; or
(ii) operation for purposes of supplying power for
distribution to the electric grid, except as specified in subparagraph
(A)(vii) of this paragraph.
(16) Functionally identical replacement--A unit that
performs the same function as the existing unit that it replaces,
with the condition that the unit replaced must be physically removed
or rendered permanently inoperable before the unit replacing it is
placed into service.
Cont'd... |