<<Prev Rule

Texas Administrative Code

Next Rule>>
TITLE 30ENVIRONMENTAL QUALITY
PART 1TEXAS COMMISSION ON ENVIRONMENTAL QUALITY
CHAPTER 117CONTROL OF AIR POLLUTION FROM NITROGEN COMPOUNDS
SUBCHAPTER BCOMBUSTION CONTROL AT MAJOR INDUSTRIAL, COMMERCIAL, AND INSTITUTIONAL SOURCES IN OZONE NONATTAINMENT AREAS
DIVISION 4DALLAS-FORT WORTH EIGHT-HOUR OZONE NONATTAINMENT AREA MAJOR SOURCES
RULE §117.435Initial Demonstration of Compliance

(a) The owner or operator of any unit subject to the emission specifications of this division shall test the unit as follows.

  (1) The unit must be tested for nitrogen oxides (NOX ), carbon monoxide (CO), and oxygen (O2) emissions while firing gaseous fuel or, as applicable, liquid and solid fuel.

  (2) Units that inject urea or ammonia into the exhaust stream for NOX control must be tested for ammonia emissions.

  (3) Initial demonstration of compliance testing must be performed in accordance with the schedule specified in §117.9030 of this title (relating to Compliance Schedule for Dallas-Fort Worth Eight-Hour Ozone Nonattainment Area Major Sources).

(b) The initial demonstration of compliance tests required by subsection (a) of this section must use the methods referenced in subsection (d) or (e) of this section and must be used for determination of initial compliance with the emission specifications of this division. Test results must be reported in the units of the applicable emission specifications and averaging periods.

(c) Any continuous emissions monitoring system (CEMS) or any predictive emissions monitoring system (PEMS) required by §117.440 of this title (relating to Continuous Demonstration of Compliance) must be installed and operational before conducting testing under subsection (a) of this section. Verification of operational status must, at a minimum, include completion of the initial monitor certification and the manufacturer's written requirements or recommendations for installation, operation, and calibration of the device or system.

(d) Compliance with the emission specifications of this division for units operating without CEMS or PEMS must be demonstrated according to the requirements of §117.8000 of this title (relating to Stack Testing Requirements).

(e) Initial compliance with the emission specifications of this division for units operating with CEMS or PEMS in accordance with §117.440 of this title, must be demonstrated after monitor certification testing using the CEMS or PEMS as follows.

  (1) For boilers and process heaters complying with a NOX emission specification in pounds per million British thermal units (lb/MMBtu) on a rolling 30-day average, NOX emissions from the unit are monitored for 30 successive unit operating days and the 30-day average emission rate is used to determine compliance with the NOX emission specification. The 30-day average emission rate is calculated as the average of all hourly emissions data recorded by the monitoring system during the 30-day test period.

  (2) For units complying with a NOX emission specification on a block one-hour average, any one-hour period while operating at the maximum rated capacity, or as near thereto as practicable is used to determine compliance with the NOX emission specification.

  (3) For units complying with a CO emission specification, on a rolling 24-hour average, any 24-hour period is used to determine compliance with the CO emission specification.

  (4) For units complying with §117.423 of this title (relating to Source Cap) a rolling 30-day average of total daily pounds of NOX emissions from the units are monitored (or calculated in accordance with §117.423(c) of this title) for 30 successive source operating days and the 30-day average emission rate is used to determine compliance with the NOX emission limit. The 30-day average emission rate is calculated as the average of all daily emissions data recorded by the monitoring and recording system during the 30-day test period. There must be no exceedances of the maximum daily cap during the 30-day test period.

(f) Compliance stack test reports must include the information required in §117.8010 of this title (relating to Compliance Stack Test Reports).


Source Note: The provisions of this §117.435 adopted to be effective June 14, 2007, 32 TexReg 3206; amended to be effective June 25, 2015, 40 TexReg 3965

Link to Texas Secretary of State Home Page | link to Texas Register home page | link to Texas Administrative Code home page | link to Open Meetings home page