<<Prev Rule

Texas Administrative Code

Next Rule>>
RULE §17.17Partial Determinations

(a) A Tier III application requesting a partial determination must be submitted for all property that is either not on the Tier I Table located in §17.14(a) of this title (relating to Tier I Pollution Control Property), or does not fully satisfy the requirements for a 100% positive use determination under this chapter. For all property for which a partial use determination is sought, the cost analysis procedure (CAP) described in subsection (c) of this section must be used.

(b) The Expedited Review List in this subsection is adopted as a nonexclusive list of facilities, devices, or methods for the control of air, water, and/or land pollution. This table consists of the list located in Texas Tax Code, §11.31(k) with changes as authorized by Texas Tax Code, §11.31(l). The commission shall review and update the items listed in this table only if there is compelling evidence to support the conclusion that the item provides pollution control benefits. The commission may remove an item from this table only if there is compelling evidence to support the conclusion that the item does not render pollution control benefits.

Attached Graphic

(c) Consistent with subsection (a) of this section, the following calculation (cost analysis procedure) must be used to determine the creditable partial percentage for a property that is filed on a Tier III application:

  (1) If no marketable product results from the use of the property, use the following equation and enter "0" for the net present value of the marketable product (NPVMP):

Attached Graphic

  (2) For property that generates a marketable product (MP), the net present value (NPV) of the MP is used to reduce the partial determination when used in the equation in the figure in paragraph (1) of this subsection. The value of the MP is calculated by subtracting the production costs of the MP from the market value of the MP. This value is then used to calculate the NPV of the MP (NPVMP) over the lifetime of the equipment. The equation for calculating NPVMP is as follows:

Attached Graphic

(d) If the cost analysis procedure of this section produces a negative number or a zero, the property is not eligible for a positive use determination.

Source Note: The provisions of this §17.17 adopted to be effective January 9, 2002, 27 TexReg 185; amended to be effective February 7, 2008, 33 TexReg 932; amended to be effective December 13, 2010, 35 TexReg 10964

Link to Texas Secretary of State Home Page | link to Texas Register home page | link to Texas Administrative Code home page | link to Open Meetings home page