| (a) A sign face may not exceed:
(1) 672 square feet in area;
(2) 25 feet in height; and
(3) 60 feet in length.
(b) For the purposes of this section, border and trim
are included as part of the sign face, and the base, apron, supports,
and other structural members, are excluded as part of the sign face.
(c) Notwithstanding the area limitation provided by
subsection (a)(1) of this section, one or more temporary protrusions
may be added to a sign, provided that the sign face, including the
protrusions, meets the height and length limitations of subsection
(a) of this section and:
(1) the area of a protrusion is located exclusively
inside of the sign face border and trim; or
(2) the area of the protrusion is outside of the sign
face border and trim, as indicated on the sign permit, and does not
exceed 10 percent of the permitted area.
(d) Except as provided in subsection (g) of this section,
a sign may have two or more sign faces that are placed back-to-back,
side-by-side, stacked, or in "V" type construction with not more than
two faces presented in each direction. If such an arrangement is used,
the sign structure or structures are considered to be one sign for
all purposes. Two sign faces which together exceed 700 square feet
in area may not face in the same direction.
(e) Two sign faces that face in the same direction
may be presented as one face by covering both faces and the area between
the faces with an advertisement, as long as the size limitations of
subsection (a) of this section are not exceeded.
(f) A sign may not have a moveable protrusion unless
authorized under this subchapter (relating to Electronic Signs).
(g) Two electronic sign faces may be located on the
same sign structure if each sign face is visible only from a different
direction of travel.
|
| Source Note: The provisions of this §21.182 adopted to be effective July 1, 2011, 36 TexReg 2418; amended to be effective June 19, 2014, 39 TexReg 4668; amended to be effective March 14, 2018, 43 TexReg 1446 |
