| (E) for point sources, emissions inventory data for
the years used to determine the SIP emissions and historical adjusted
emissions;
(F) the most stringent emission rate and the most stringent
emission level, considering all applicable local, state, and federal
requirements;
(G) a complete description of the protocol used to
calculate the emission reduction generated; and
(H) the actual calculations performed by the generator
to determine the amount of ERCs generated.
(4) ERCs will be made enforceable by one of the following
methods:
(A) amending or altering a new source review permit
to reflect the emission reduction and set a new maximum allowable
emission limit;
(B) voiding a new source review permit when a facility
has been shut down; or
(C) for any facility without a new source review permit
that is otherwise authorized by commission rule, certifying the emission
reduction and the new maximum emission limit on one or more forms
specified by the executive director, including a Certification of
Emission Limits (Form APD-CERT) submitted through e-permitting and
an Emissions Banking and Trading Certification of Emission Reductions
Form (Form EBT-CERT), or other forms considered equivalent by the
executive director.
|
| Source Note: The provisions of this §101.303 adopted to be effective January 17, 2003, 28 TexReg 83; amended to be effective December 2, 2004, 29 TexReg 11038; amended to be effective June 25, 2015, 40 TexReg 3848; amended to be effective October 12, 2017, 42 TexReg 5441 |
