<<Prev Rule

Texas Administrative Code

Next Rule>>
TITLE 30ENVIRONMENTAL QUALITY
PART 1TEXAS COMMISSION ON ENVIRONMENTAL QUALITY
CHAPTER 334UNDERGROUND AND ABOVEGROUND STORAGE TANKS
SUBCHAPTER CTECHNICAL STANDARDS
RULE §334.48General Operating and Management Requirements

(a) Prevention of releases. All owners and operators of underground storage tank (UST) systems shall ensure that the systems are operated, maintained, and managed in a manner that will prevent releases of regulated substances from such systems.

(b) UST system management. UST systems shall be operated, maintained, and managed in accordance with accepted industry practices.

(c) Inventory control. Inventory control procedures shall be in accordance with §334.50(d)(1)(B) of this title. Complete and accurate inventory records shall be maintained in accordance with §334.10 of this title (relating to Reporting and Recordkeeping).

(d) Spill and overfill control. All owners and operators shall ensure that spills and overfills of regulated substances do not occur and that all spill and overfill prevention equipment is properly operated and maintained in accordance with §334.51 of this title (relating to Spill and Overfill Prevention and Control).

(e) Operational requirements for release detection equipment. Owners and operators of all new and existing UST systems shall ensure that all release detection equipment installed as part of a UST system pursuant to §334.50 of this title is maintained in good operating condition and electronic and mechanical components are tested for proper operation in accordance with one of the following: manufacturer's instructions, a code of practice developed by a nationally recognized association or independent testing laboratory, or requirements determined by the executive director to be no less protective of human health and the environment than listed in this subsection.

  (1) Beginning on January 1, 2021, a test of the proper operation of release detection equipment must be performed at least annually and, at a minimum, as applicable to the facility, cover the following components and criteria:

    (A) automatic tank gauge and other controllers: test alarm, verify system configuration, and test battery backup;

    (B) probes and sensors: inspect for residual buildup, ensure floats move freely, ensure shaft is not damaged; ensure cables are free of kinks and breaks, and test alarm operability and communication with controller;

    (C) automatic line leak detector: test operation to meet criteria in §334.50(b)(2)(A)(i) of this title by simulating a leak;

    (D) vacuum pumps and pressure gauges: ensure proper communication with sensors and controller; and

    (E) hand-held electronic sampling equipment associated with groundwater and vapor monitoring: ensure proper operation.

  (2) The code of practice that may be used to comply with paragraph (1) of this subsection is: Petroleum Equipment Institute (PEI) Publication RP1200, "Recommended Practices for the Testing and Verification of Spill, Overfill, Leak Detection and Secondary Containment Equipment at UST Facilities."

(f) Operation requirements for corrosion protection systems. All owners and operators of UST systems shall ensure that all required UST system components are continuously protected from corrosion, and that all corrosion protection systems are inspected and tested, in accordance with the applicable provisions of §334.49 of this title (relating to Corrosion Protection).

(g) Periodic testing of spill prevention equipment and containment sumps used for interstitial monitoring of piping and periodic inspection of overfill prevention equipment.

  (1) Owners and operators of UST systems with spill and overfill prevention equipment and containment sumps used for interstitial monitoring of piping must meet these requirements to ensure the equipment is operating properly and will prevent releases to the environment:

    (A) Spill prevention equipment (such as a catchment basin, spill bucket, or other spill containment device) and containment sumps used for interstitial monitoring of piping must prevent releases to the environment by meeting one of the following:

      (i) The equipment is double-walled and the integrity of both walls is periodically monitored at a frequency not less than the frequency of the walkthrough inspections described in subsection (h) of this section. Owners and operators must begin meeting the requirements in clause (ii) of this subparagraph and conduct a test within 30 days of discontinuing periodic monitoring of this equipment; or

      (ii) The spill prevention equipment and containment sumps used for interstitial monitoring of piping (when interstitial monitoring is the primary release detection method) are tested at least once every three years to ensure the equipment is liquid tight by using vacuum, pressure, or liquid testing in accordance with one of the following criteria:

        (I) requirements developed by the manufacturer;

        (II) code of practice developed by a nationally recognized association or independent testing laboratory; or

        (III) low liquid level test method - the sump may be tested by filling the sump with liquid to a level that is three inches higher than the activation point of the sensor provided the following conditions are met:

          (-a-) the sensor is mounted and maintained at the lowest point of the sump in accordance with the requirements in §334.45(d)(1)(E)(vi) of this title (relating to Technical Standards for New Underground Storage Tank Systems);

          (-b-) the sensor is annually tested for functionality in accordance with the requirements in subsection (e)(1)(B) of this section;

          (-c-) the sensor will trigger a positive shutdown of:

            (-1-) the individual dispenser associated with that sump; or

            (-2-) submersible turbine pump associated with that sump; and

          (-d-) all on-site operators are trained to immediately notify the appropriate A or B level operator of the shutdown; or

        (IV) requirements determined by the executive director to be no less protective of human health and the environment than the requirements listed in subclauses (I) - (III) of this clause.

      (iii) Liquids that are used for testing as described in clause (ii) of this subparagraph may be reused for further liquid testing in other sumps, either at the same facility or at other facilities. The discharge must be made in compliance with the applicable wastewater discharge requirements or be disposed of in accordance with Chapters 330 or 335 of this title (relating to Municipal Solid Waste and Industrial Solid Waste and Municipal Hazardous Waste).

    (B) Overfill prevention equipment must be inspected at least once every three years. At a minimum, the inspection must ensure that overfill prevention equipment is set to activate at the correct level specified in §334.51(b)(2)(C) of this title and will activate when a regulated substance reaches that level.

    (C) Codes of practice. The following code of practice may be used to comply with subparagraphs (A)(ii)(II) and (B) of this paragraph: PEI Publication RP1200, "Recommended Practices for the Testing and Verification of Spill, Overfill, Leak Detection and Secondary Containment Equipment at UST Facilities."

  (2) Implementation dates. Owners and operators shall meet these requirements:

    (A) UST systems in use before September 1, 2018:

      (i) The requirements listed in paragraph (1) of this subsection shall apply on January 1, 2021.

      (ii) Initial spill prevention equipment and containment sump testing, and overfill prevention inspections (relating to the requirements in paragraph (1) of this subsection) shall be conducted by January 1, 2021.

    (B) UST systems brought into use on or after September 1, 2018.

      (i) The requirements listed in paragraph (1) of this subsection shall apply on the date the UST system was brought into use.

      (ii) Initial spill prevention equipment and containment sump testing, and overfill prevention inspections shall be conducted by the date the UST system was brought into use.

  (3) Owners and operators shall maintain records as follows (in accordance with §334.10(b)(2)(B) of this title) for spill prevention equipment, containment sumps used for interstitial monitoring of piping, and overfill prevention equipment.

    (A) All records of testing and inspection must be maintained for five years.

    (B) For spill prevention equipment and containment sumps used for interstitial monitoring of piping not tested every three years, documentation showing that the prevention equipment is double-walled and the integrity of both walls is periodically monitored must be maintained for as long as the equipment is periodically monitored.

(h) Periodic operation and maintenance walkthrough inspections. To properly operate and maintain UST systems, not later than January 1, 2021, owners and operators must meet one of the following.

  (1) Conduct a walkthrough inspection that, at a minimum, checks the following equipment as specified in the following subparagraphs.

Cont'd...

Next Page

Link to Texas Secretary of State Home Page | link to Texas Register home page | link to Texas Administrative Code home page | link to Open Meetings home page