| (a) A dental assistant may not position or expose dental
x-rays unless the dental assistant holds a dental assistant radiology
certificate issued by the State Board of Dental Examiners under this
section.
(b) To be eligible for a dental assistant radiology
certificate under this section, an applicant must present on or accompanying
an application form approved by the State Board of Dental Examiners
proof satisfactory to the Board that the applicant has:
(1) Paid all application, examination and licensing
fees required by law and Board rules and regulations;
(2) Graduated from an accredited high school or holds
a certificate of high school equivalency, General Equivalency Diploma
(GED);
(3) Submitted fingerprints for the retrieval of criminal
history record information;
(4) Successfully completed a current hands-on course
in basic life support; and,
(5) Either:
(A) taken and passed a course of instruction and an
examination administered by the State Board of Dental Examiners or
its designated agent, that fulfills the requirements in subsection
(h) of this section; or,
(B) if the applicant is certified as a dental assistant
by the Dental Assisting National Board, taken and passed a jurisprudence
examination administered by the State Board of Dental Examiners or
its designated agent.
(c) The State Board of Dental Examiners has established
a staggered dental assistant registration system comprised of initial
registration periods followed by biennial registrations (i.e., renewals).
The initial, staggered registration periods will range from 18 months
to 30 months. The length of the initial registration period will be
determined by the registrant's birth month, but will be no less than
18 months. The expiration of the initial registration will be based
on the registrants' birth month.
(d) Subsequent to the initial registration period,
a registered dental assistant's biennial renewal will occur on the
first day of the month that follows the last month of the dental assistant
initial registration period.
(1) Approximately 60 days prior to the expiration date
of the initial dental assistant registration period, renewal notices
will be mailed to all registered dental assistants who have that expiration
date.
(2) A dental assistant registered under this section
who wishes to renew his or her registration must:
(A) Pay a renewal fee set by Board rule;
(B) Submit proof that the applicant has successfully
completed a current hands-on course in basic life support; and,
(C) Complete continuing education as required by §114.12
of this chapter.
(3) A registration expired for one year or more may
not be renewed.
(4) Up to 6 hours of continuing education may be carried
forward from the year preceding the current renewal period.
(e) Applications for registration or for renewal of
registration must be submitted to the office of the State Board of
Dental Examiners.
(f) An application for registration is filed with the
State Board of Dental Examiners when it is actually received, date-stamped,
and logged-in by the State Board of Dental Examiners along with all
required documentation and fees. An incomplete application for registration
and fee will be returned to applicant within three working days with
an explanation of additional documentation or information needed.
(g) A dental assistant shall display a current registration
certificate in each office where the dental assistant provides services
for which registration is required by this chapter. When a dental
assistant provides such services at more than one location, a duplicate
registration certificate issued by the Board may be displayed. Photocopies
are not acceptable. The duplicate may be obtained from the State Board
of Dental Examiners for a fee set by the Board.
(h) Radiology. Courses administered to fulfill the
requirements of a Dental Assistant Radiology Certificate must cover
the following course objectives identified by the Dental Assistant
Advisory Committee:
(1) At the end of this course of instruction, the student
should be able to:
(A) Apply principles of radiation safety in the operation
of radiographic equipment.
(i) Explain factors affecting x-ray production.
(ii) Explain x-ray machine factors that influence radiation
safety.
(iii) Identify differences between primary radiation
and scattered (secondary) radiation.
(iv) Describe protocol in suspected x-ray machine malfunctions.
(B) Practice safety measures for patient protection.
(i) Explain major cause of unnecessary radiation exposure.
(ii) Identify short and long-term effects of radiation
on cells and tissues.
(iii) Identify ways to reduce radiation exposure to
patients.
(iv) Explain guidelines to determine frequency of radiation
exposure.
(C) Practice safety measures for operator protection.
(i) Explain basic radiation physics and biology related
to operator exposure.
(ii) Explain sources of radiation to operators while
exposing radiographs.
(iii) Identify safety measures to reduce operator radiation
exposure.
(D) Identify and select infection control techniques
and barriers to minimize cross-contamination according to ADA/CDC
guidelines.
(E) Utilize patient management techniques before, during,
and after radiographic exposure.
(i) Address patient concerns regarding radiation exposure.
(ii) Select appropriate patient management techniques
for radiographic exposure.
(F) Select appropriate intraoral radiographic technique.
(i) Identify appropriate armamentarium for radiographic
techniques.
(ii) Select appropriate film size and film speed.
(iii) Expose radiographs.
(G) Practice infection control procedures for radiographic
processing.
(H) Prepare, maintain, and replenish radiographic solutions
for manual and automatic processors.
(I) Process exposed intra- and extraoral radiographs
manually and with automatic processors.
(i) Identify optimum conditions and procedures for
processing radiographs.
(ii) Identify and correct errors related to radiographic
processing and improper film handling.
(J) Store film and chemical agents used in radiographic
procedures according to regulatory guidelines.
(K) Dispose of all chemical agents and other materials
used in dental radiographic procedures.
(L) Mount radiographs using facial view.
(i) Identify anatomical landmarks to aid in correct
mounting.
(ii) Match specific tooth views to specified tooth
mount windows.
(iii) Utilize optimum viewing techniques.
(iv) Label the radiographic mount appropriately.
(M) Identify anatomical structures, dental materials
and patient characteristics observed on radiographs.
(N) Evaluate radiographs for diagnostic value.
(i) Identify diagnostically acceptable radiographs.
(ii) Identify and correct causes of errors on intraoral
radiographs.
(O) Understand basic principles of extraoral radiology.
(P) Select the appropriate film and equipment.
(Q) Prepare patient for exposure.
(R) Expose extraoral radiographs.
(S) Identify and correct causes of errors on extraoral
radiographs.
(T) Explain the concept of digital radiography.
(U) Select appropriate equipment.
(V) Expose digital radiographs.
(W) Identify and correct causes of errors on digital
radiographs.
(X) Utilize quality assurance procedures in the dental
office for radiographic procedures.
(Y) Prepare radiographs to comply with legal requirements
for viewing and duplication.
(i) Explain methods for duplicating radiographs.
(ii) Explain reasons for exposing and retaining radiographs.
(Z) Comply with HIPAA/Patient Privacy Rules and Regulations.
(2) Infection control. At the end of this course of
instruction, the student should be able to:
(A) Follow standards and guidelines of occupational
safety for dental office personnel.
(i) Utilize regulations in the OSHA/CDC Bloodborne
Pathogens Standard.
Cont'd... |
