The owner or operator of each petroleum refinery; synthetic organic chemical, polymer, resin, or methyl tert-butyl ether manufacturing process; or natural gas/gasoline processing operation in Brazoria, Chambers, Fort Bend, Galveston, Harris, Liberty, Montgomery, and Waller Counties shall demonstrate compliance with the requirements of this division (relating to Fugitive Emissions) in accordance with the following schedule. (1) The initial monitoring of all components for which monitoring is required under this division, but are not required to be monitored under Subchapter D, Division 3 of this chapter (relating to Fugitive Emission Control in Petroleum Refining, Natural Gas/Gasoline Processing, and Petrochemical Processes in Ozone Nonattainment Areas), must occur as soon as practicable, but no later than March 31, 2004, except that: (A) the schedule in §115.781(f) of this title (relating to General Monitoring and Inspection Requirements) applies to blind flanges, caps, or plugs at the end of a pipe or line containing highly-reactive volatile organic compounds, sight glasses, meters, gauges, connectors, bolted manways, heat exchanger heads, hatches, and sump covers for which the owner or operator has notified the appropriate regional office and any local air pollution control program with jurisdiction that §115.781(f) of this title will be used to establish the monitoring schedule for these components; and (B) on or before March 31, 2004, the owner or operator shall notify the appropriate regional office and any local air pollution control program with jurisdiction that §115.781(f) of this title will be used to establish the monitoring schedule for blind flanges, caps, or plugs at the end of a pipe or line containing highly-reactive volatile organic compounds, sight glasses, meters, gauges, connectors, bolted manways, heat exchanger heads, hatches, and sump covers. The owner or operator shall monitor all of these components at least one time in each process unit by April 1, 2006, and then conduct subsequent monitoring at the frequencies noted in §115.781(f) of this title. For those process units with an initial start-up date after March 31, 2004, the notification of the intent to use §115.781(f) of this title shall be made within 60 days after the initial start-up date. In this case, the owner or operator shall monitor all of these components at least one time in each process unit within one year of the initial start-up date, and then conduct subsequent monitoring at the frequencies noted in §115.781(f) of this title. (2) All requirements in §115.782 of this title (relating to Procedures and Schedule for Leak Repair and Follow-up) and all equipment upgrades required by §115.783 of this title (relating to Equipment Standards) must be made as soon as practicable, but no later than March 31, 2004, except that control devices used to comply with the requirements of §115.783(2) of this title must be in compliance in accordance with §115.729 of this title (relating to Counties and Compliance Schedules). (3) The initial independent third-party audit required by §115.788 of this title (relating to Audit Provisions) shall be completed and the results of the audit submitted to the executive director as soon as practicable, but no later than December 31, 2005. (4) Compliance with the recordkeeping required by §115.786 of this title (relating to Recordkeeping Requirements) must be implemented and made available upon request to authorized representatives of the executive director, United States Environmental Protection Agency, or any local air pollution control agency having jurisdiction as soon as practicable, but no later than March 31, 2004. (5) The initial monitoring of pump seals and compressor seals using a leak definition of 500 parts per million by volume, as required by §115.781(b)(9) of this title, must begin as soon as practicable, but no later than March 31, 2004. |
