| (3) An alteration data plate shall be made of a material
that will not deteriorate over time and shall be permanently placed
so that it cannot be removed without destruction.
(4) The data plate shall be placed adjacent to the
original data plate in an easily accessible location as designated
in the alteration plans, but shall not be located on any readily removable
item such as a cabinet door or similar component. Location of the
data plate on the cover of the electrical distribution panel is acceptable.
(5) An alteration data plate shall contain, as a minimum,
the information required on a manufacturer's data plate as required
by §70.71(d)(2) -(11) plus the following information:
(A) the name, address, and registration number assigned
by the department of the industrialized builder, or the name, address,
and alteration permit number assigned by the department of the owner
of the building; and
(B) the Texas alteration decal numbers.
|
| Source Note: The provisions of this §70.74 adopted to be effective April 13, 1990, 15 TexReg 1787; amended to be effective May 17, 2004, 29 TexReg 4867; amended to be effective May 1, 2005, 30 TexReg 2504; amended to be effective January 1, 2010, 34 TexReg 9409; amended to be effective May 1, 2014, 39 TexReg 3412 |
